Question 11 : In a Schottky diode, the silcon is usually
1. N-type
2. P-type
3. un-doped semiconductor
4. silicon is not used
View Answer   Discuss with Members

Question 12 : In a Schottky diode, the aluminum metal acts as a __________
1. anode
2. cathode
3. gate
4. common terminal
View Answer   Discuss with Members

Question 13 : The peak inverse current I_P for a power diode is given by the expression
1. I_P=t + di/dt
2. I_P=t * log ⁡i
3. I_P=t * di/dt
4. I_P=t * ∫ t*i dt
View Answer   Discuss with Members

Question 14 : In case of an ideal power diode, the leakage current flows from
1. anode to cathode
2. cathode to anode
3. in both the directions
4. leakage current does not flow
View Answer   Discuss with Members

Question 15 : The power loss in which of the following cases would be the maximum?
1. When both V & I are minimum
2. When both V & I are maximum
3. When only V is maximum
4. When only I is maximum
View Answer   Discuss with Members

Question 16 : Which of the following diodes uses a metal-semiconductor junction?
1. General purpose diodes
2. Fast recovery diodes
3. Schottky diode
4. None of the mentioned
View Answer   Discuss with Members

Question 17 : Zener diodes allow a current to flow in the reverse direction, when the
1. voltage reaches above a certain value
2. temperature reaches above a certain value
3. current always flows in the reverse direction only
4. current cannot flow in the reverse direction
View Answer   Discuss with Members

Question 18 : As compared to a p-n junction diode(of the same rating), a Schottky diode has ___________
1. higher cut-in voltage
2. lower reverse leakage current
3. higher operating frequency
4. higher switching time
View Answer   Discuss with Members

Question 19 : For a p-n junction diode, the peak inverse current & the reverse recovery time are dependent on
1. inverse voltage
2. forward Voltage
3. di/dt
4. all of the above mentioned
View Answer   Discuss with Members

Question 20 : A Schottky diode _____
1. has current flow due to holes only
2. has no reverse recovery time
3. has large amount of storage charges
4. has zero cut-in voltage
View Answer   Discuss with Members